Landoll MCL/MCC/MCLS/MLCS/MCCS 1483, 1643, 1803 RIGID PULVI-MULCHER - Manual (Page 41)

OPERATION
3-3
Depth Control
Maximum operating depth of six (6) inches is obtained
with depth pin in front hole. Each subsequent hole
reduces the depth approximately one (1) inch. See
Figure 3-2.
In addition to the five depth settings, you have one other
option; by using the optional hole setting you can achieve
a working range of approximately 4” maximum down to
“zero or completely inactive teeth.” See Figure 3-3.
Figure 3-3: Non-Independent Depth Control Adjustment

CAUTION
Wheel Adjustment
Allow just enough looseness so each wheel will turn by
itself. If the wheels become worn, loosen the axle clamp
at the end of each roller and tighten as needed. Optimum
performance is achieved when the roller segments are
operated snugly together.
Land Leveler - Optional
Adjust the Land Leveler to the highest position that does
the required job. Its purpose is to break up and scatter
any large lumps that are above the normal ground level. If
the soil pushes ahead of the bar, it is set too low. Striking
large rocks will damage the leveler bar and possibly other
parts of the machine.
V Leveler - Optional
Adjust the V Leveler to the highest position that does the
required job. Its purpose is to break up and displace any
large lumps that are above the normal ground level with
minimal planing. If the soil pushes ahead of the bar, it is
set too low. Striking large rocks will damage the leveler
bar and possibly other parts of the machine. See
Figure 3-4.
Center Frame Non-Independent Tooth Control
Depth Control Adjustment
Front
Rockshaft
Normal Position
6" Depth
Optional Position
4" Depth
Do not attempt to remove the pin connecting the
cylinder to the rockshaft if there is any load on
the cylinder. The machine will fall and may cause
injury.