Landoll MCL/MCC/MCLS/MLCS/MCCS 1483, 1643, 1803 RIGID PULVI-MULCHER - Manual (Page 23)

ASSEMBLY
2-13
Tooth or Tine Installation
After you have all eight brackets assembled, pencil mark
the tooth locations on the tooth tubes.
See Figure 2-17.
Slide the tooth tubes through the brackets. Both of the
tooth tubes must be centered on the machine - an equal
length of tube extending out beyond the outer brackets.
Slide each tooth up against the tooth tube bracket, this
helps prevent the tube from sliding.
See Figure 2-13.
Then fix the tubes in place by assembling straps and
U-bolts to each tooth tube. Locate them on the outside of
the inner tooth tube brackets.
See Figure 2-13.
Figure 2-13: Fixing the Tubes in Place
Install S-Tines or C-Teeth as shown. (For S-Tine
installation assemble points to spring tines before
mounting onto tooth tubes.) See Figures 2-14, 2-15 and
2-16.
Figure 2-14: S-Tine
Figure 2-15: C-Tooth
Tube
Tooth Tube
Bracket
1/2-13 Hex Nut
1/2 Lock Washer
U-Bolt,1/2-13
5D921
Clamp Strap
5C078
Tooth Tube
Bracket
Tube
1/2-13 Hex Nut
1/2 Lock Washer
U-Bolt,1/2-13
5D921
Clamp Strap
5C078
1/2-13 X 3-1/2
Carriage Bolt,
Clamp
5J080
1/2-13 Hex Nut
S-Tine
Spring Tooth
Tooth Clamp
1/2-13 Hex Nut Lock Washer
Clamp Strap
1/2