Kinze 3140 Stack Fold Planter Rev. 7/14 - Manual (Page 17)

TM
Model 3140 M0245-01
9/12 2-3
Machine Operation
Upper Hitch Pin
Category 3N And 3 Pin And Hardware
USE TOP
SET OF
HOLES
TOP VIEw
7⁄16 " Lynch Pin
1¼" x 4½" Upper Hitch Pin
Optional Category 2 Pin And Hardware
TOP VIEw
1"-8 Lock Nut
USE
BOTTOM
SET OF
HOLES
Top Link Bushings (D10419)
1"-8 x 6" Upper Hitch Pin (Cap Screw)
3. Back tractor up to planter. Position lower hitch pins and bushings as shown in the following diagrams for your type of
tractor hitch. Line up holes and insert hitch pins and lock in place with pins provided. It may be necessary to change
the length of the upper link with the adjusting handle.
The upper hitch point has two holes. The hitch pin must be positioned in the lower hole for use with tractors equipped
with Category 2 quick hitch. The lower hole is also recommended for use on tractors without a quick hitch. Some
Category 2 tractors without a quick hitch are designed to accommodate the upper attaching holes. Consult tractor
manufacturer.
The hitch pin must be positioned in the upper hole for use with tractors equipped with Category 3N and 3 hitches.
When using a quick hitch (customer-supplied), match pin location to pin spacing in the quick hitch. Adjust the tractor
upper link until the quick hitch is vertical when in the planting position.
Dual lift assist wheel equipped machines require use of
a quick hitch (customer-supplied) and the top link pin is
not used.
wARNINg
Never transport machine with lift assist wheels without quick hitch. If
this type of hitch is not in place, a sudden stop could allow the toolbar
to rotate forward causing personal injury or damage to the equipment.
Lower Hitch Pins
1¼" x 8¾"
Lower Hitch Pin
7/16 " Lynch Pins
TOP VIEw TOP VIEw
Lower Link
Bushing (D10418)
⅜ " Lynch Pin
11¾" Lower Hitch Pin
⅜ " x 2" Cap Screw
and Lock Nut
Optional Category 2 Pin And Hardware Category 3N And 3 Pin And Hardware