JUMO 902930 Wtrans Transmitter RTD Temperature Probe with Wireless Data Transmission Operating Manual - Manual (Page 40)

7 Setup program
40
7.4 Probe configuration
This chapter explains the configuration of a probe via the setup program. Prerequisite being
that the probe and the PC are connected via an interface.
7.4.1 Establishing the communication
A differentiation is made between two different way of proceeding when establishing the com-
munication between probe and setup program:
•
Establish the communication with "Device settings assistant”.
This is the case when the setup program is used for the first time
(list of devices empty).
• Establish the communication without "Device settings assistant”.
This is the case when the receiver/probe and setup program have already communicated
(list of devices with entries).
Establishing the communication using the assistant
How to proceed:
Step Activity
1 Start the setup program.
2 Select the "Establish connection" function in the "Data transfer” menu.
The "Assistant for the device settings" appears.
3 Select the probe under the "Device version" and confirm by pressing "Continue".
4 Confirm the PC communication interface "Serial interface" by pressing "Continue".
5 Select the serial interface (e.g. COM1) and confirm with "Continue”.
6 Confirm the MU protocol (transmitter) by pressing "Continue".
7 Exit the assistant by pressing "Finish".
The device list with the selected probe appears.
8 Click on the "Connect" button.
The device list is closed, the assistant terminated and the communication between probe
and setup program established.