JUMO 902930 Wtrans Transmitter RTD Temperature Probe with Wireless Data Transmission Operating Manual - Manual (Page 36)

7 Setup program
36
7.2 Required hardware and software
The following hardware and software prerequisites must be fulfilled for operation and software
installation:
Minimum configuration
• Intel Pentium III
1
or higher
• Microsoft Windows 2000 or XP 2
• 256 MB central memory
• CD drive
• Mouse
• one free USB port or
• one free serial interface (depending on the interface/port used)
• 120 MB free hard disk memory
Recommended configuration
• Intel Pentium 4 1
• Microsoft Windows XP 2
• 512 MB central memory
Information about Windows 2000 or XP
If several users are managed on the computer, ensure that the user is logged in, who will work
with the program later. Ensure that the user has administrator rights while installing the soft-
ware. After installation, the rights can be restricted again.
In the event of non-observance of this information, correct and complete installation cannot be
guaranteed!
1
Intel and Pentium are registered trademarks of Intel Corporation.
2 Microsoft and Windows are registered trademarks of Microsoft Corporation.
TIP!
If no communication with the transmitter (probe) or the receiver is possible through the setup
program, update the setup program.
The latest setup program is available as download on the manufacturer's internet page.