JUMO 902930 Wtrans Transmitter RTD Temperature Probe with Wireless Data Transmission Operating Manual - Manual (Page 31)

31
5 Installation
5.3 Fitting the wall holder and probe
Figure 11: Fitting the wall holder and probe
Proceed as follows to install the wall holder and the probe:
1 Holes for wall holder 4 Plastic circlip
2 Clamping bush (use for different sheath
diameters) 5 Probe sheath
3 Cheese head screws M 5
Step Activity
1 Fasten the wall holder to the wall using three suitable screws and dowels (not included in
the delivery scope).
2 Insert the clamping bush into the wall holder from above.
Align the guide open end in direction to the wall.
Slightly tighten the two cheese head screws M 5 using the screwdriver.
3 Insert the sheath from above into the clamping bush and tighten with the two cheese head
screws M 5.