beautypg.com

7 setup program, 1 general information about the setup program, Setup program – JUMO 902930 Wtrans Transmitter RTD Temperature Probe with Wireless Data Transmission Operating Manual User Manual

Page 35: General information about the setup program

background image

35

7 Setup program

7.1

General information about the setup program

The setup program serves to configure probes and receivers by means of a PC. The configu-
ration data can be archived on data carriers and printed.
Configurable parameters are:

Probe ID

Transmission interval

Transmission frequency (with 915 MHz only)

The factory settings are:

Probe ID consecutively

Transmission interval

Transmission frequency 868.4 MHz (Europe) or
915.4 MHz (America, Australia, Canada, New Zealand);
ten frequencies for transmitter and receiver can be set in the 915 MHz frequency band

The setup program can be used to overwrite changed parameters with the factory settings at
any time.
The connection between probe and PC is established via a PC interface (USB/TTL or TTL/
RS232 converter).

Figure 12: Setup program of the probe