JUMO 709050 IPC IGBT Power Converter IPC 200A Operating Manual User Manual
JUMO Equipment
Table of contents
Document Outline
- 2 Introduction
- 3 Installation
- 4 Electrical connection
- 5 Settings
- 5.1 Operating principle
- 5.2 Setting switches S101, S103, S104, S105, S106 and X106
- 5.3 Subordinate control loop
- 5.4 Load voltage adjustment
- 5.5 Control inputs
- 5.6 Firing pulse inhibit
- 5.7 Resistance output
- 5.8 Trimmer settings
- 5.9 Setting the base load (min. Power adjust)
- 5.10 Setting the current limit (max. current adjust)
- 5.11 Total and partial load failure monitoring (load fail adjust)
- 5.12 Safety cut-out in the power section (IGBT)
- 5.13 Adjusting the output level signal (output adjust U2, P , I2 )
- 6 Technical data
- 7 Troubleshooting