JULABO LC 4 Temperature controller - Manual (Page 34)

Remote control
34
9.3. Status messages
Message Description
00 MANUAL STOP Controller in "OFF" state
01 MANUAL START Controller in keypad control mode
02 REMOTE STOP Controller in "r OFF" state
03 REMOTE START Controller in remote control mode
9.4. Error messages
Message
Description
-01 SAFETY-TEMP ALARM
Safety temperature alarm
-05 TEMPERATURE MEASUREMENT
ALARM
Error in measuring system.
-07 I2C-BUS WRITE ERROR
-07 I2C-BUS READ ERROR
-07 I2C-BUS READ/WRITE ERROR
Internal errors
-08 INVALID COMMAND
Invalid command
-10 VALUE TOO SMALL Entered value too small
-11 VALUE TOO LARGE
Entered value too large
-12 VALUE NOT VALID Value not valid
-13 COMMAND NOT ALLOWED IN
CURRENT OPERATING MODE
Invalid command in current operating mode