INCRA Pro Fence System - Manual (Page 6)

6
Installing the Extender Bar
Applications
Fig.9 shows the proper placement for your Stop
Extender Bar. Insert the Extender Bar with the scale
facing the front of the fence, then slide the bar in the
T-slot until the ends are flush and lock in place using
the supplied #10 – 32 x 1 ⁄ 2 " thumbscrew, 5 ⁄ 8 " o.d. nylon
washer and rectangular nut as shown.
A second Stop Extender Bar can be purchased
should you want to increase the stop range beyond both
ends of your INCRA PRO Fence.
CAUTION: Always install the Extender Bar in the UPPER
T-slot, never the lower one.
Extender Bar Stop
Position the Extender Bar about 2" beyond the fence end
and using the supplied 1 ⁄ 4 "
–
20 x 1 ⁄ 2 " nylon thumbscrew,
attach the Extender Bar Stop. See Fig. 10. The Stop can
be used on either end of the Extender Bar to increase
your stop range beyond the ends of the INCRA PRO
Fence. When not in use, the Stop can be turned around
and locked to the Extender Bar (see Fig. 11). This storage
position places the Stop out of the way, leaving the front
face of the INCRA PRO Fence uninterrupted for through
cut operations.
#10 – 32 x 1 ⁄ 2 "
thumbscrew
Fig. 9
Extender bar
Front face of fence
5 ⁄ 8 " o.d.
nylon washer
Rectangular nut
Extender bar
1 ⁄ 4 " – 20 x 1 ⁄ 2 "
nylon thumbscrew
Extender Bar Stop
Fig. 11
Extender Bar Stop
storage position
INCRA Stop
When used in conjunction with your new INCRA PRO
Fence, the INCRA Stop provides the same precise rack
positioning capabilities that your INCRA Jig offers. The
sliding scale in the top of your fence becomes a versatile
reference for use in setting stop positions at the router
table and the drill press. The sliding plastic stop strip
on the INCRA Stop permits micro-adjusting of the stop
positions between 1 ⁄ 32 " steps. The Stop can function
on either the outfeed or infeed end of the fence with any
thickness of stock, even rabbeted boards. Two INCRA
Stops can work together at opposite ends of the fence for
many advanced operations, such as multiple mortises and
slots.
Fig. 12
INCRA Stop
Fig. 10
Extender Bar Stop