HiRO H50212 - Manual (Page 44)

802.11n WLAN ADSL2+ Router User’s Guide
44
8
Internet Access
This chapter describes how to configure the way that your
device connects to the Internet. Your ISP determines what type
of Internet access you should use and provides you with any
information that you need in order to configure the Internet
access to your device.
Your device needs the following address information in order to
access the Internet:
ATM PVC To configure ATM PVC, enter the VPI
and VCI provided by ISP. Select the
Service Type Index, Service Category
and enter the following information:
 Peak Cell Rate
 Sustainable Cell Rate
 Maximum Burst Size
Connection Type To configure the connection type, select
the protocol and encapsulation type as
indicated by ISP. Supported Protocol
types are:
 RFC1483 Bridged
 RFC1483 MER
 PPPoE
 PPPoA
 RFC1483
Routed
Supported Encapsulation types are:
 VCMUX
 LLC/SNAP
WAN IP Settings To configure WAN IP settings, enter the
information as indicated by ISP.
Enable/Disable the Access Concentrator
option. Either enter the WAN IP or select
the option to automatically obtain IP
address.
Check as applicable the following two
options:
 Enable NAT
 Add default Route
Broadband
Username and
Password To configure Broadband Username and
Password, enter the user name and
password details. Also set the session
establishment condition as one of the
following:
 Continuous