HiRO H50212 - Manual (Page 186)

User’s Guide Configuring your Computers
186
5. Now you could see the result below:
Ping6
Once you have your DSL device configured, it is a good idea to
make sure you can ping the network. A ping command sends a
message to the host you specify. If the host receives the
message, it sends messages in reply. To use it, you must know
the IP address of the host you are trying to communicate with
and enter the IP address in the Host Address field. Click Go! To
start the ping command, the ping result will then be shown in
this page.
6. From
the head Maintenance menu, click on Diagnostic ->
Ping6. The following page is displayed:
Fields Description
Host The IP address you want to ping.
Function
buttons Description
PING To start the ping command