Heidolph Hei-VAP Advantage - Manual (Page 30)

Set-up and Start-up
22 Hei-VAP Value, Hei-VAP Advantage
EN
EN
1. Remove the vapor tube from the packaging.
Figure 4 –7: Install the vapor tube
2. Remove the threaded clamping screw (1) on the drive unit; remove the tension
spring (2) and PTFE 26 vacuum seal (3).
Figure 4 –8: Locking button
3. Continue to press the locking button (Figure 4 –8 (1)).
4. Remove the screw coupling connection of the vapor tube (Figure 4-7 (6) from the
drive unit.
5. Pull out the clamping sleeve (Figure 4 –7 (5).
6. Push the vapor tube coupling clamp (Figure 4 –7 (6)) and clamping sleeve (Figure 4-
7 (5)) with the bead first to the vapor tube (Figure 4 –7 (7)). Verify that the bead au-
dibly snaps into the groove of the vapor tube (Figure 4 –7 (7)).
7. Push the vapor tube (Figure 4 –7 (7) into the drive unit with the pre-assembled parts.
8. Continue to press the locking button (Figure 4 –8 (1)).
9. Manually tighten the vapor tube coupling clamp (Figure 4 –7 (6)) with the threaded
connection of the motor drive (Figure 4 –7 (4)) till a tight connection is made.
Locking buttons
3
4
5
6
7
1
2
1