EZWatch EZ-TRACK-DOME - Manual (Page 6)

AGC Level – Manually allows the user to increase the gain of the video signal. Adjusting
this could adversely affect the camera’s image quality.
Bright Level – Allows the camera to automatically control the camera gain and iris
opening using a unique algorithm.
Spot AE – This function controls whether or not the Automatic Exposure looks at the
center of the image or the image as a whole when adjusting the exposure settings.
Adjusting this may enhance or detract image quality depending on whether or not the
camera is looking at an object that is brighter/darker than its surroundings.
Dome Settings 1 -> Motion Submenu
These settings control how the camera moves and acts while moving. It consists of 5
settings and 4 sub-menus.
Auto Flip – This setting allows the camera to automatically rotate and flip when it is
rotating downwards. If it’s off, and the customer rotates the camera down, the camera
stops when looking straight down. If it’s on, and the customer rotates the camera down,
when it reaches straight down it rotates 180 degrees and continues up the opposite side,
allowing for better tracking of a person moving beneath the camera.
Proportional pan – This setting tells the camera to rotate slower when zoomed in,
allowing for much finer control over the view. If the setting is off then it will rotate just
as fast no matter how far zoomed in or out it is.
Park Time – This setting tells the camera how long to wait with no input before
performing the ‘park action’. This is so that after being taken over for manual control, it
can resume a previous action uninterrupted. Adjustable 15 seconds to 12 hours.
Park Action – This setting tells the camera what to do after the park time elapses. Valid
options are None, Auto Scan, Random Scan, Frame Scan, go to Preset 1 or 8, begin
following Patterns 1 through 4, Auto-Cruise through presets, Begin Motion Tracking, or
Repeat Last. Repeat last tells the camera to perform whatever action it was doing before
it was interrupted with manual control.
Scan Speed – How fast the camera rotates when in Auto, Random, and Frame Scan
modes. It can be set from 1 to 32 degrees per second.
Set Scan – This sub-menu allows you to set where the camera will stop when in Frame
Scan mode.
Manual Limit – This allows you to set a manual left/right limit when controlling the
camera. This limit does not affect presets, scanning, or motion tracking but will prevent a
person controlling the camera with the joystick from moving further left or right.