EZWatch EZ-TRACK-DOME - Manual (Page 15)

Armor-Pro Standalone P/T/Z Set up :
Coaxial Video Cable
2-Conductor Wire
To connect the EZ-TRACK camera to an Armor Pro Standalone DVR, you will need to
connect two wires from the camera (The RS485 Positive and Negative wires) to the
joystick controller. The wires will need to be run directly from the joystick to the RS485
Positive and Negative ports on the back of the joystick. Always match positive to positive
and negative to negative.
Run another pair of wires from the Positive and Negative RS485 ports on the joystick to
the RS485 ports located on the back of the Armor Pro unit. The wire from the positive
port on the joystick needs to run to the RS485 + port, and the negative port on the
joystick needs to run to the RS485 – port. If you have a 16-channel Armor Pro unit, the
ports are labeled A (positive) and B (negative).
Equipment Needed :
• P/T/Z Camera
• P/T/Z Joystick (Optional, but highly recommended)
• Armor Pro Standalone 4-channel or 16-channel DVR
• 2-Conductor twisted pair wire used to run communication from the camera to the
joystick, and to run from the joystick to the Standalone DVR.