EZWatch EZ-TRACK-DOME - Manual (Page 13)

Appendix A – Camera Switch Settings
SW01 – Camera Protocol (Switches 1-4 only)
Protocol
Dip1 Dip2 Dip3 Dip4 Dip5 Dip6 Dip7 Dip8
Nanwang On Off Off Off
Pelco-P Off On Off Off
Pelco-D On On Off Off
Kalatel Off Off On Off
SW01 – Camera Baud Rate (Swithces 5-8 only)
Baud Rate
Dip1 Dip2 Dip3 Dip4 Dip5 Dip6 Dip7 Dip8
1200 BPS On Off Off Off
2400 BPS Off On Off Off
4800 BPS On On Off Off
9600 BPS Off Off On Off
19200 BPS On Off On Off
SW02 – Camera Address (SEE NOTE BELOW)
Address Dip1
Dip2 Dip3 Dip4 Dip5 Dip6 Dip7 Dip8
0 Off Off Off Off Off Off Off Off
1 On Off Off Off Off Off Off Off
2 Off On Off Off Off Off Off Off
3 On On Off Off Off Off Off Off
4 Off Off On Off Off Off Off Off
5 On Off On Off Off Off Off Off
6 Off On On Off Off Off Off Off
7 On On On Off Off Off Off Off
8 Off Off Off On Off Off Off Off
9 On Off Off On Off Off Off Off
10 Off On Off On Off Off Off Off
11 On On Off On Off Off Off Off
12 Off Off On On Off Off Off Off
13 On Off On On Off Off Off Off
14 Off On On On Off Off Off Off
15 On On On On Off Off Off Off
NOTE – The camera must be addressed as one number BELOW the camera number in
the controller! Camera 1 within the controller will correspond to address 0 on the camera.
Failure to address the camera properly will result in an inability to control the camera, or
may result in controlling an incorrect camera.