EUCHNER FSA Light - Manual (Page 39)

Manual EKS Light and Light FSA
9 Setup
Perform setup in the following sequence:
1. Set the DIP switches on the read station (see section 4.1 Function of the DIP switches).
2. Check mounting and electrical connection are correct (see section 6 and section 7).
 After connection of the power supply, the LED on the front of the Electronic-Key adapter illuminates.
3. Insert valid Electronic-Key into the Electronic-Key adapter.
 The LED illuminates yellow if there is a functional Electronic-Key in the Electronic-Key adapter.
10 Exclusion of liability
Exclusion of liability under the following conditions:
 incorrect use
 non-compliance with safety regulations
 if mounting and electrical connection are carried out by unauthorized personnel
 if modifications are made
11 Service and repair
 No servicing is required.
 Remove dirt from the Electronic-Key and the Electronic-Key adapter using a soft cloth and solvent-free,
non-abrasive cleaning agents.
 Repairs must be performed only by the manufacturer.
12 Guarantee
The "General Terms and Conditions" of EUCHNER GmbH + Co. KG apply.
110845-04-03/12 Subject to technical modifications Page 39/40