EUCHNER CETx-AS-xxx-CB-xxx (Multicode) - Manual (Page 19)

Operating Instructions Safety Switch CET.-AS-...-CB-...
19
Setup
LED indicators
LED Color State Significance
STATE green
illumi-
nated Normal operation
(further signal functions see System status table
page 21)
flashing
ASi red/green Status messages see chapter AS-Interface status messages page 18
STATE red
illumi-
nated
Internal electronics fault
LED 1 red freely configurable*
LED 2 green freely configurable*
*) Can vary depending on version. See data sheet.
Initial setup
1. Apply operating voltage to the safety switch.
¨ The green LED flashes cyclically one time and signals that it is in standby
state.
2. Move actuator to the read head (observe distance < S
ao
).
¨ The green LED illuminates continuously and indicates the detection of the
actuator.
LED1 /
(rot/red)
LED 2
OUT D
(grün/green)
ASI
(grün/rot
green/red)
STATE
(grün/rot
green/red)