ERICO S4 Series LENTON Bolt Couplers - Manual

LENTON taper threaded couplers can be
assembled with a standard pipe wrench.
The LENTON inspection wrench, available
from ERICO, may be used to periodically
check tightness (see chart below).
Proper LENTON inspection wrench settings
should be used for the given bar sizes.
Installation:
Step 1 - Remove the bar end protectors, if present, from
the ends of the taper threaded rebar. Visually inspect the
threads to ensure that they are free of concrete, rust or
other debris and are not damaged.
Use a wire brush if threads need to be cleaned.
Step 2 - Inspect part number on the coupler to ensure it is
the proper size for the bar being spliced. (See chart below)
Step 3 - If present, remove cap or internal coupler protector
from the coupler. Visually inspect internal thread to ensure
it is free of concrete or other debris.
Step 4 - Refer to Step 1 above for bar cleanliness. Place
the taper end of the coupler onto the taper threaded bar
and rotate the coupler clockwise until hand tight,
(approx. 4-1/2 turns). If using a standard pipe wrench,
rotate the coupler clockwise to securely tighten the coupler.
The LENTON inspection wrench can be used by an
inspector to periodically check tightness (see chart below
for wrench setting).
* The integrity, torque, and proper installation criteria of the straight threaded connection should be evaluated by a qualified engineer.
TECHNICAL SUPPORT:
www.erico.com PDF096_G
INSTRUCTION SHEET
1 of 1
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
WARNING:
1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at www.erico.com and from your ERICO
customer service representative.
2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
3. All instructions must be completely followed to ensure proper and safe installation and performance.
4. Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property damage, serious bodily injury and death.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
LENTON® Bolt Couplers
S4, S5 Series
© 2008,2011,2013,2014 ERICO
International Corporation.