ERICO LPAW70T Smooth Weave "Y Splice" - Manual

Installation Torque:
220 in-lb [25 N-m]
Installation Tools:
5/16" Hex
Downconductor
Branch
Connector
60 mm
[2.36 in]
Downconductor
50 mm
[1.97 in]
Branch Connector
Installation Instructions:
Strip 60 mm [2.36 in] of insulation from the downconductor 1.
and 50 mm [1.97 in] of insulation from the end of the
branch connector.
Remove oxides from bare conductors and connector 2.
with wire brush. (Required for Aluminum; Recommended
for Copper)
Apply oxide inhibitor (Penetrox A-13 or equivalent) to 3.
conductors and connector. (Required for Aluminum;
Recommended for Copper)
Apply threadlocker (Loctite
®
263
TM
or equivalent)* to both 4.
screw and connector threads.
Tighten screw to installation torque. 5.
* Loctite
®
271
TM
threadlocker can be used as a substitute for
Loctite ® 263 TM . Loctite ® 7649 TM activator needs to be applied
if using Loctite ® 271 TM .
TECHNICAL SUPPORT
www.erico.com IP8263_A 1 OF 1
INSTRUCTION SHEET
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
Loctite is a registered trademark of Henkel Corporation
Smooth Weave "Y" Splice
LPAW50T & LPAW70T
© 2013 ERICO International Corporation.