ERICO IP8242 ECLA Installation Tooling for Dual Rated Aluminum Connectors - Manual

Select proper lugs or splice connector for the size of cable being installed, make sure 1.
that the size matches the description in the table below.
Strip the insulation from the conductor to a length so that the stripped area of the 2.
conductor can be completely inserted into and fill the barrel of the lug or splice.
Carefully strip the insulation from the conductor without nicking the strands.
Wire brush the stripped portion of the conductor to remove oxide films. 3.
The stripped portion of the conductor must be clean and inserted completely into 4.
the connector barrel.
Using the tool and die combination specified for that in the table below, install 5.
crimps, leaving a space of 1/8" maximum between successive crimps unless
overlapped to fill the connector barrel at the referenced location illustrated.
Lug
Splice
Global Part No. Cable Size Die Color
Burndy® Y35
Die Sets
Burndy® Y35
Die Sets for
Smooth Weave
Die Index
--- 8 AWG Blue U8CABT --- 374
ECLA6S14 6 AWG Gray U6CABT --- 346
ECLA4S14, ECLA4S516 4 AWG Green U4CABT --- 375
ECLA2S14, ECLA2S38 2 AWG Pink U2CABT --- 348
ECLA1S38, ECLA1S516 1 AWG Gold U1CART --- 471
ECLA1/0S38 1/0 AWG Tan U25ART --- 296
ECLA2/0S12 2/0 AWG Olive U26ART --- 297
ECLA3/0S12 3/0 AWG Ruby U27ART --- 467
ECLA4/0S12, ECLA4/0S14,
ECLA4/0S38, ECLA4/0S58,
ECLA4/0S516
4/0 AWG White U28ART U28RT 298
ECLA250S516,
ECLA250S12, ECLA250S38,
ECLA250S58
250 MCM Red U29ART U28ART 324
ECLA300S12 300 MCM Blue U30ART --- 470
ECLA350S12 350 MCM Brown U31ART --- 299
ECLA400S12 400 MCM Green U32ART --- 472
ECLA500S12 500 MCM Pink U34ART --- 300
ECLA600S58 600 MCM Black U36ART --- 473
ECLA750S58 750 MCM Yellow Red U39ART --- 936
TECHNICAL SUPPORT
www.erico.com IP8242_B 1 OF 1
INSTRUCTION SHEET
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
Burndy is a registered trademark of Hubbell Incorporated.
ECLA
Installation Tooling for Dual Rated Aluminum Connectors
© 2012, 2013 ERICO International
Corporation.