ERICO TDX100SM - Manual

Side Mounting Bracket

2002 ERICO

Inc, 34600 Solon Rd, Solon, OH 44139 Page 1 of 1 Doc: HBCR1651, Rev: 2, Date: OCTOBER 28, 2002
TDX50SM
TDX100SM
Side Mounting Instructions
PREPARATION
DANGER: Electrical shock or burn hazard.
Installation of TVSS should be made by qualified
personnel. Failure to lockout electrical power
during installation or maintenance can result in fatal
electrocution or severe burns.
These installation instructions apply for the installation of the
TDX range of Surge Protectors onto the side of a Load Center
using the TDX Side Mounting Brackets. These instructions are
to be used in conjunction with the installation instructions for
the TDX product.
It is recommended that this installation use a 90° pulling elbow.
As dimensions of various manufacturers pulling elbows vary,
check fit before installing.
NOTE:
Separate Side Mounting Kits are available for either the TDX50
range of products or for the TDX100 & TDX150 range of
products. Please ensure that this kit is the correct model for the
application intended.
Each kit Contains:
a) 2 x Mounting Brackets
b) Instructions
Quick Installation
1. Disconnect and lockout electrical power to the electrical
panel (load center / panelboard / circuit breaker box) where
the TDX is to be installed. Follow all applicable electrical
codes and procedures.
2. Loosen side screws in both TDX end plates as shown in
Figure 1. Screws should be loosened on the side to be fixed
to load center only. Install TDX Side Mounting Brackets and
retighten TDX screws. There is no need to remove the
screws
3. Attach 90° Pulling Elbow (not included in this kit) to the
TDX unit.
4. Ensure panel is isolated and pre-drill holes for conduit
elbow and mounting screws. Align TDX unit and fasten to
Load Center with appropriate fasteners.
5. Complete electrical TVSS connection as per TVSS
instructions.