ERICO Type PL Connection Grounding - Manual

Prior to making a connection, read and follow the full instruction sheet IPRNS, the full
Instruction sheet IPP, the full instruction sheet shipped with CADWELD (IPX), and
special instructions below.
Place mold on lug and cable with lug in as far as possible and butt cable to lug. 1.
Cut riser off with bolt cutters. 2.
When using sleeve, let cable end protrude .13” [3.2 mm] beyond end of sleeve.
3.
Without Sleeve With Sleeve
®
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
TECHNICAL SUPPORT:
www.erico.com IP6726_C
INSTRUCTION SHEET
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
1 OF 1
© 1995, 2013
ERICO International Corporation
WARNING:
1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
www.erico.com and from your ERICO customer service representative.
2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
3. All instructions must be completely followed to ensure proper and safe installation and performance.
4. Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
damage, serious bodily injury and death.
Type PL Connection
Grounding