beautypg.com

ERICO IP7059 Type LS User Manual

Type ls

background image

Prior to making a connection, read and follow the full instruction sheet IPRNS, IPP,

and the full instruction sheet shipped with CADWELD (IPX), and special

instructions below.

Pack with ERICO packing material between cables (As shown in Figure 1).

1.

Position mold on lug and cables. Gap lug and cables directly under tap holes.

2.

The gap is noted on mold tag.

When using special frames, lock top halves of mold together. Lock top and

3.

bottom sections together.

Use ERICO packing material (As shown in Figure 2). Pack entirely around

4.

cables, especially at junctions of cable.

ERICO Packing

Material

Gap as Noted

Pack with ERICO

Packing Material

Figure 2

Figure 1

®

TECHNICAL SUPPORT:

www.erico.com

INSTRUCTION SHEET

1 OF 1

© 1995, 2012, 2013

ERICO International Corporation

TECHNICAL SUPPORT:

www.erico.com

IP7059_C

INSTRUCTION SHEET

1 OF 1

Type LS

WARNING:

ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at

1.

www.erico.com and from your ERICO customer service representative.

ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.

2.

All instructions must be completely followed to ensure proper and safe installation and performance.

3.

Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property

4.

damage, serious bodily injury and death.

SAFETY INSTRUCTIONS:

All governing codes and regulations and those required by the job site must be observed.

Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

Table of contents