ERICO IP6954 Cable to Ground Wire User Manual

Cable to ground wire

Prior to making a connection, read and follow the full instruction sheets IPP, IPX,

IPRNS (included only with molds used on rail property not to rail) and the special

instructions below.

Insert rod fully into mold cavity

Insert conductors into mold cavity with end of conductors under center of tap hole.

TECHNICAL SUPPORT:

www.erico.com

IP6954_B

INSTRUCTION SHEET

1 OF 1

ERICO International Corporation

Cable To Ground Wire

WARNING:

ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at

www.erico.com and from your ERICO customer service representative.

ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.

All instructions must be completely followed to ensure proper and safe installation and performance.

Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property

damage, serious bodily injury and death.

SAFETY INSTRUCTIONS:

All governing codes and regulations and those required by the job site must be observed.

Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

Table of contents

Document Outline

Sheet1