ERICO IP6937 Cable to Lug Horizontal Splice User Manual
Cable to lug horizontal splice
Prior to making a connection, read and follow the full instruction sheet IPRNS, the full
Instruction sheet IPP, the full instruction sheet shipped with CADWELD (IPX), and
special instructions below.
Position mold on cables and lug with lug notch facing down (As shown above).
1.
Gap lug and cables directly under tap holes as noted on mold tag.
Lock top sections of mold together. Then lock top and bottom sections together.
2.
®
Gap as Noted
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
TECHNICAL SUPPORT:
www.erico.com
IP6937_D
INSTRUCTION SHEET
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
1 OF 1
© 1995, 2012, 2013
ERICO International Corporation
WARNING:
1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
www.erico.com and from your ERICO customer service representative.
2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
3. All instructions must be completely followed to ensure proper and safe installation and performance.
4. Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
damage, serious bodily injury and death.
Cable to Lug
Horizontal Splice