ERICO IP6688 Horizontal Tee, Multiple Tap User Manual
Horizontal tee, multiple tap
Prior to making a connection, read and follow the full instruction sheet IPRNS, IPP,
and the full instruction sheet shipped with CADWELD® (IPX) and special
instructions below.
Do not cut run cable.
1.
Position run cable in bottom of mold. Gap tap cables .13” [3 mm] from side of
2.
run cable.
Lock top sections together and lock to lower section of mold.
3.
After completing weld, unclamp top from bottom first before removing other
4.
clamps.
.13" [3.2 mm] Gap
TECHNICAL SUPPORT:
www.erico.com
IP6688_C
INSTRUCTION SHEET
1 OF 1
© 1995, 2012, 2013
ERICO International Corporation
Horizontal Tee,
Multiple Tap
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be completely followed to ensure proper and safe installation and performance.
3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.