ERICO IP6674 Horizontal Splice, Single to Multiple Cable - Manual

Prior to making a connection, read and follow the full instruction sheet IPRNS, IPP, and
the full instruction sheet shipped with CADWELD® (IPX) and special instructions below.
Position mold on cables with cables butted under center of tap hole. 1.
If using sleeve let cable protrude .063" [1.6 mm] beyond end of sleeve. 2.
Use CADWELD mold sealer (ERICO part number T403) between cables to help 3.
prevent leakage.
TECHNICAL SUPPORT:
www.erico.com IP6674_C
INSTRUCTION SHEET
1 OF 1
© 1995, 2012, 2013
ERICO International Corporation
TECHNICAL SUPPORT:
www.erico.com IP6674_C
INSTRUCTION SHEET
1 OF 1
Horizontal Splice,
Single to Multiple Cable
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.