ERICO IP6640 Cable to Ground Rod Horizontal Splice User Manual
Cable to ground rod horizontal splice

Gap as Noted on Mold Tag
Prior to making a connection, read and follow the full instruction sheet IPRNS, IPP,
and the full instruction sheet shipped with CADWELD (IPX) and special
instructions below.
Place mold on cable and rod with ends butting under center of tap hole unless
1.
gap is noted on mold tag.
Follow standard welding procedures.
2.
®
TECHNICAL SUPPORT:
www.erico.com
INSTRUCTION SHEET
1 OF 1
© 1995, 2012, 2013
ERICO International Corporation
TECHNICAL SUPPORT:
www.erico.com
IP6640_E
INSTRUCTION SHEET
1 OF 1
Cable to Ground Rod Horizontal Splice
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be completely followed to ensure proper and safe installation and performance.
3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.