ERICO IP6572 Type SB User Manual
ERICO Accessories for electrical
Prior to making a connection, read and follow the full instruction sheet IPRNS, the full
instruction sheet IPP, the full instruction sheet shipped with CADWELD (IPX), and special
instructions below.
Let cable protrude .06" [1.6 mm] beyond end of sleeve.
1.
Position mold on cables with cables butted under of tap hole (As shown above).
2.
Use ERICO packing material between cables to prevent leakage.
3.
®
Sleeve
Sleeve
TECHNICAL SUPPORT:
www.erico.com
IP6572
INSTRUCTION SHEET
1 OF 1
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
TECHNICAL SUPPORT:
www.erico.com
IP6572_C
INSTRUCTION SHEET
1 OF 1
© 1995, 2013
ERICO International Corporation
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be completely followed to ensure proper and safe installation and performance.
3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.