ERICO CADWELD Rod and Cable to Vertical Steel Surface Style HV - Manual

.25 6.4
GAP
Cable
Vertical
steel surface
Mold
Rod
L159 Handle Clamp
Prior to making a connection, read and follow the full instruction sheet (IPP)
shipped with CADWELD mold and special instructions below.
1, Place rod in mold with 1/4 inch gap from vertical steel surface.
3, The vertical leg of the rod should be nested between the two pins on the back
surface of the mold to insure vertical alignment.
2, L159 will allow the rod to pass through if located close to the mold.
4, The vertical cable should be in contact with the horizontal rod.
WARNING:
1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
www.erico.com and from your ERICO customer service representative.
2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
3. All instructions must be completely followed to ensure proper and safe installation and performance.
4. Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property damage,
serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERITECH, ERIFLEX, and LENTON are registered trademarks of ERICO International Corporation.
TECHNICAL SUPPORT
www.erico.com IP8208_B 1 OF 1
INSTRUCTION SHEET
CADWELD
Rod and Cable to Vertical steel surface
Style HV
©2012 ERICO International Corporation
“