ERICO CADWELD Cable to Bus/Lug, Ver Ell Bus Down - Manual

.12 3.2
Gap
Lug positioned
in mold
flush at bottom
Cable
Sleeve
Handle Clamp L160
side
Lug Section
Side view of Lug
showing
orientation
of hole
Prior to making a connection, read and follow the full instruction sheet (IPP & IPRNS)
shipped with CADWELD mold and special instructions below.
4, Position cable/sleeve and lug in mold as shown above.
6, Follow standard welding procedures
5, Gap cable 0.12[3.2] from bus.
1, Place the cable with the sleeve into the mold and close this section of the mold
using handle clamp L160.
2, Close and lock the lug section of the mold.
3, Place lug into the mold.
TECHNICAL SUPPORT:
www.erico.com IP8253_A
INSTRUCTION SHEET
1 OF 1 © 2012 ERICO International Corporation
CADWELD®
CABLE TO BUS/LUG, VERT ELL BUS DOWN
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.