Environmental Express AutoBlock III - Manual (Page 4)

INTRODUCTION
The AutoBlock has been designed specifically for your laboratory by providing safe,
clean and efficient digestions. It is capable of digesting water, wastewater, soils, and
other materials typically digested using hotplate chemistry.
Unpacking
Retain all packaging material for a
minimum period of 90-days.
See Warranty for complete details.
Your AutoBlock has been packaged in a custom crate
for shipping purposes. Spend adequate time reading
this instruction manual before unpacking your
AutoBlock. While unpacking keep in mind there are
many fragile components. A quality control sheet from
the factory has been included. Use this list to inventory
components, as they are unpacked.
Note:
Residual water may be found in the internal plumbing of
your AutoBlock. This includes the pump, reagent and
drain lines. This water is non-hazardous, and was used
for system check during quality control inspection.
What’s included
SINGLE UNIT
1
AutoBlock Manual
1 AutoBlock Unit
1 AutoBlock Electrical Unit
1 Power Cord
3 Racks
6’
½”ID Drain Tube
1 10L Carboy
1 ½” Barb Fitting
5 Flangeless Nut
5+2 extra Flangeless Ferrules
25’ 1/16”ID
Reagent Tubing
DUAL UNIT
1
AutoBlock Manual
1 AutoBlock Unit
1 AutoBlock Electrical Unit
1 Power Cord
3 Racks
6’
½”ID Drain Tube
1 10L Carboy
1 ½” Barb Fitting
10 Flangeless Nut
10+2 extra Flangeless Ferrules
50’ 1/16”ID
Reagent Tubing
Uncrating Instructions
• Cut banding from crate, use standard safety precautions.
• Lift the entire cover from the crate.
• Carefully remove
Foam Filler
Inner Box from the side. This box contains the electrical box, power cord & manual
Front Door that is secured to the back of the cabinet
• Remove the 10L carboy, 3-racks, reagent tubing & start up kit. There are several pieces of
packaging material in place for protection. All material must be removed.
• Remove the protective tape from the sample probe cap, reagent entry plate, JC connectors,
pump compartment door & touch screen.
• The unit will need to be cleaned from residue during shipment. Using compressed air, clean the
inside of the AutoBlock.
The AutoBlock unit is now ready to be installed. Please read installation instructions .
ENVIRONMENTAL EXPRESS
For technical support call 1-800-745-8218 or send email to [email protected]
5528INTRO rev 3 4 9/10/09