Elkhart Brass Cobra 7200 EXM Monitor - Manual (Page 7)

7
OEM Interface Module - 7070
The OEM Interface Module is used in conjunction with either the Elkhart
Brass or customer supplied joystick, or OEM installed switches. The
OEM Interface Module may be configured to handle switching power or
ground. The Interface Module provides the option of mounting a joystick
or switches in the apparatus cab to control all monitor functions,
including oscillation. The OEM Interface Module may be powered with
12 or 24 Volts.
MONITOR ACCESSORY
Position Feedback Display - 7051
All EXM monitors come with Absolute Position Feedback sensors. These
sensors provide constant feedback to the monitors’ processor even
when the monitor is moved via manual override. This information is
then transmitted to the Position Feedback Display.
EXM CAN Stow Module- 7095
The EXM CAN Stow Module provides electrical outputs to which an OEM
can connect to in order to enable/disable truck operations based on
whether an EXM monitor is stowed or not stowed. This could be used,
for example, for a truck that has an aerial or other movable object that
may hit the monitor if moved when the monitor is not stowed. These
outputs could also be used to turn OEM-supplied indicator lights on or
off depending on the monitor stow state.
External RF Antenna Module - 7062
The External RF Antenna Module can be utilized with an RF equipped
7070 OEM Interface Module. The 10ft. extension harness allows the
antenna to be mounted in a position with a better line of sight to the
monitor. Use of the external RF antenna module is required for aerial
applications. The external antenna should also be used with the OEM
interface module when RF interference is likely.
RF Transceiver Module - 7061
The RF Transceiver Module can be used with any input controller to
enable RF communication within the EXM system.
Light Kit – 7083/7084
The Light Kit provides illumination specifically for the areas targeted by
EXM monitors. The Light Kit is mounted on top of the discharge elbow
and follows the aim of the monitor. Installation instructions are included
with the light kit.
7083 – Light Kit with light control module and light bar included
7084 – Light Kit with light control module only