Elkhart Brass Cobra 7200 EXM Monitor - Manual (Page 13)

13
1
2
Valve Plug
Joystick Controller and OEM Interface Module –
 Using the Joystick Controller template shown in the
Component Mounting Templates section, drill all holes shown
through the panel intended for mounting the Joystick
Controller.
 Mount the Joystick Controller using 10-24 x ½” fasteners
secured with blue Loctite 242 or equivalent.
 Using the OEM Interface template shown in the Component
Mounting Templates section, drill all 4 of the 7/32” holes
shown.
 Mount the OEM Interface Module with four (4) 10-24 x ½”
fasteners secured with blue Loctite 242 or equivalent.
 Connect the plug coming from the valve buttons on the
Joystick Controller to the valve plug on the OEM Interface
Module. (See picture to the right)
 Connect the plug coming from the Joystick Controller stick to plug 2 on the OEM Interface
Module. (See picture to the right)
 If the Joystick/OEM will use CAN communication, connect the green, black, and blue leads
coming from plug 1 to the appropriate CAN line. If the CAN leads will not be used, replace
wires with plugs.
Converting the Panel Mount Controller into a
Handheld Controller –
(Using Handheld Conversion Kit)
 Handheld Conversion Kit will include Battery
Pack, Docking Station, and all hardware.
 Install a RF Transceiver Module into the back of
the Panel Mount Controller as instructed in the
Panel Mount installation section.
 Connect Battery Pack plugs to the Panel Mount
Controller as shown.
 The CAN connector will not be used and should
be placed inside the Battery Pack as shown.
 Attach Battery Pack to the Panel Mount
Controller using the provided 10-24 x ¾”
screws. Torque screws to 50-60 in-lbs. Ensure
no wires are pinched or exposed.