Elkhart Brass Sidewinder EXM Quick Install Guide User Manual

Sidewinder exm, Quick install guide

Step 1. Mount Monitor onto base

Step 2. Attach Nozzle to Monitor

Thread monitor onto base using Loctite
592 thread sealant or equivalent.

MOUNT MONITOR - FLANGE

P/N 98326000 Rev C

Install a 20A fuse (12VDC) into the
positive power lead; 10A fuse for 24VDC.

MOUNT MONITOR - THREADED

Position monitor discharge elbow parallel
to the ground. Ensure gasket is inside
nozzle swivel before installing.

Step 3. Confirm Connections

Confirm that all connections are tight
and all electrical connections have been
reconnected.

POSITION DISCHARGE

Hand tighten nozzle to monitor using
swivel.

INSTALL NOZZLE

Adjust flow by pressing down on locking
lever and rotating nozzle to desired flow
setting.

ADJUST FLOW SETTING

Confirm that locking lever is snapped
securely into position.

LOCKING LEVER PLACEMENT

Quick Install Guide

ELKHART BRASS

1302 WEST BEARDSLEY AVE • P.O. BOX 1127

ELKHART, IN 46514

PHONE: 574.295.8330 • 800.346.0250

FAX: 574.293.9914

SIDEWINDER EXM

NOTE: We recommend using 16 AWG for monitor power and ground. See
installation instructions section of the Sidewinder EXM manual (98317000)
for length to gauge recommendations.

NOTE: If a Quick Connect is being installed, please refer to the Quick
Connect Install Guide. Guide can be found under the Sidewinder EXM
manual section at www.elkhartbrass.com.

Loosen swivel and reposition nozzle so
the locking lever is on the bottom.

REPOSITION NOZZLE

Tighten swivel using a spanner wrench to
ensure a secure connection.

TIGHTEN NOZZLE

Connect nozzle & monitor two-way
connectors.

CONNECT POWER

16g

90°