Weigh – DIGIWEIGH DWP-102NS User Manual

Page 18

be entered through numeric keys, then ignore this step,

d. Press [PCENT];

e. Press [TARE] to enter,

Reference mass is obtained by either one of the below: -
 By applying the reference mass is applied on step c, or
 In case there is no reference weight applied to platform, the last

reference mass used will be display. To confirm press [TARE]

g. This instrument is now ready for percentage calculation. Any other

weight applied to the platform will be displayed as a percentage of the

reference mass.

Press

[Weigh]

back weighing function.

6.9 ANIMAL WEIGHING FUNCTION

Follow the below steps to enter Animal Weighing Function: -

a. select the desired weight unit,

b. If a container will be used, place this container to platform and press

[TARE] to tare off the weight of it.

c. Press [ANI] to Animal Weighing Function (Ani) appears,

d. Now is ready to weighing animal
e. Display Ani. AUTO INDICATOR appears to indicator Animal Weighing

Function is in effect.

Set the Animal weighing parameter .

Press [SET], Display RS232 ,shift to Animal; Press [TARE] to enter

g. Display last filter (FLt) value applied. Select the preferred filter value

by pressing [CNT] or [UNIT] key, 3 filer values are available: -


FLt 1 = Fast

Animal weighing function of this instrument should not be used for trade purposes,

Animal weighing function does not support memory accumulation (M+) function.

Animal Weighing function will not operate when weight is less than 20d (or 20d

for dual

range).

It is a trade off between motion filtering and accuracy. The faster the filter, the shorter the

amount of time over which the averaging is taken. The slower the filter, the longer averaging

time will take before a reading is displayed. It is recommended that FLt 3 should be applied

first. Should situation requires, change to a lower FLt number.

This manual is related to the following products:

DWP-102N