DIGIWEIGH DWP-102NS - Manual (Page 16)

of d. While this multiple factor must be an integer. Thus, in case the
exact tare weight is not equal to the multiplied value, maximum
possible error of the preset tare function is ±0.5d.
2. Manual tare is possible when preset tare is in function.
3. Preset Tare is also governed by Repeated Tare
6.5 MEMORY ACCUMULATION FUNCTION
6.5.1 To Accumulate a Transaction to Memory
2 3
a. Press [Prt]
4
to save and accumulate data of current transaction to
memory,
b. This instrument returns to normal display status after 2 seconds,
c. Repeat a to c for subsequent transactions
5
,
NOTE: -
1. Unstable weight will not be accumulated to memory. If Prt is
pressed when weight is unstable, this instrument will reject this
command and response with beeps.
6.5.2 Memory Recall and Clearance
a. Press MC to recall total accumulated weight from memory,
b. After MC
is pressed, This instrument displays “≡ n” (n means the
number of transactions accumulated) follow by the total accumulated
weight stored in memory,
c. At this point: -
 Press [ZERO] to quit, or
 Press [ZERO] followed by [Weigh] to clear memory and return
operation.
6.6 FUNCTION MODES
Besides weighing function, this instrument is equipped with the below
supplementary function modes: -
 Piece Count,
 Percentage,
2
Memory Accumulation Function support weighing function only.
3
All data stored will be erased when this instrument is powered off.
4
or press [PRINT] if RS232 –Manual-ACC = ON
6. below how many d , can accumulate again