DIGIWEIGH DWP-102NS - Manual (Page 14)

6. INSTRUCTION FOR USE
6.1 POWER ON
Powered on this instrument, it will: -
a. Display software number and revision (if any)
b. Display all display segments,
c. This instrument is now ready for operation.
6.2 START WEIGHING
a. If zero weight cannot be obtained when unloaded, press [ZERO]. After
[ZERO] is pressed, the ZERO INDICATOR will appear. Refer to
SPECIFICATIONS for maximum zero range,
b. Always place an object onto platform gently. Excessive force applied
to platform may cause damage to the weight sensor,
c. The weight of the object is displayed on thus unit automatically,
d. It is a good practice to remove all loads from platform after weighing. It
will prolong the life of the weight sensor.
6.3 ABOUT WEIGH UNIT CONVERSION
Depends on the internal settings, this instrument supports kg , g, lb and oz
And can convert when weighing status by the setting of UNIT(on)
When a 3 or 4 place (0.000 or 0.0000) decimal place is selected, reading in
g is possible during normal operation by the setting of UNIT(on)
The weight unit employed before power off will be employed when this
instrument is turned on again.
6.4 TARE OFF THE WEIGHT OF A CONTAINER
Tare function is used to temporarily set the scale to zero (such as
cancelling the weight of a box or a container) in order to get the net weight
result
6.4.1 Manual Tare