Dascom DT-230 User Guide - Manual (Page 62)

Tally Dascom DT-210/230
51
The commands listed below in the first column are defined as “obsolete commands” in the ESC/POS
command system.
This printer supports both upward‐compatible commands and obsolete commands. However, the
upward‐compatible commands are recommended to use.
Obsolete command Upward‐compatible command
ESC i Partial cut (one point left uncut) GS V
ESC m Partial cut (three points left uncut) GS V
ESC u Transmit peripheral device status GS r
ESC v Transmit paper sensor status GS r
FS p Print NV bit image GS ( L
FS q Define NV bit image GS ( L
GS v 0 Print raster bit image GS ( L
“Obsolete commands” are commands that are supported by legacy models; however it is
recommended to replace them with upward‐compatible commands, because they will not
be supported in the future products.