Dascom DT-230 User Guide - Manual (Page 60)

Tally Dascom DT-210/230
49
Command Name
ESC a Select justification
ESC c 3 Select paper sensor(s) to output paper‐end signals
ESC c 4 Select paper sensor(s) to stop printing
ESC c 5 Enable/disable panel buttons
ESC d Print and feed n lines
ESC p Generate pulse
ESC t Select character code table
ESC { Turn upside‐down print mode on/off
FS g 1 Write to NV user memory
FS g 2 Read from NV user memory
GS ! Select character size
GS $ Set absolute vertical print position in page mode
GS ( A Execute test print
GS ( D Enable/disable real‐time command
GS ( E
Set user setup commands
Change into the user setting mode.
End the user setting mode session.
Set the customized setting values.
Transmit the customized setting values.
Set the configuration item for the serial interface.
Transmit the configuration item for the serial interface.
GS ( H
Request transmission of response or status
Set the process ID response.
GS ( K Select print control method(s)
Select the print speed.
GS ( L / GS 8 L
Set graphics data
Transmit the NV graphics memory capacity.
Print the graphics data in the print buffer.
Transmit the remaining capacity of the NV graphics
memory.
Transmit the key code list for defined NV graphics.
Delete all NV graphics data.
Delete the specified NV graphics data.
Define the NV graphics data (raster format).
Print the specified NV graphics data.
Store the graphics data in the print buffer (raster format).