Dascom DT-230 User Guide - Manual (Page 31)

Tally Dascom DT-210/230
20
•DIP Switches 2
SW Function ON OFF Default
2‐1 Reserved ‐ ‐ OFF
2‐2 Internal bell control Internal bell disable Internal bell enable OFF
2‐3 Auto Cutter Disable Enable OFF
2‐4 BUSY Condition Receive Buffer Full
Offline or Receive
Buffer Full
OFF
2‐5 OFF
2‐6 OFF
2‐7
Print Density Refer to the following table 2
OFF
2‐8 Near‐End Sensor Status Disable Enable OFF
 Parallel and USB2.0 Interface
• DIP Switches 1
SW Function ON OFF Default
1‐1 Auto Line Feed at CR Enable Disable OFF
1‐2
~
1‐8
Reserved
‐
‐ OFF
• DIP Switches 2
SW Function ON OFF Default
2‐1 Reserved ‐ ‐ OFF
2‐2 Internal bell control Internal bell disable Internal bell enable OFF
2‐3 Auto Cutter Disable Enable OFF
2‐4 BUSY Condition Receive Buffer Full
Offline or Receive
Buffer Enable
OFF
2‐5 OFF
2‐6 OFF
2‐7
Print Density Refer to the following Table 2
OFF
2‐8 Near‐End Sensor Status Disable Enable OFF