COATS RC-50M Rim Clamp Tire Changer - Manual (Page 11)

Note: For tube type tires, mount the lower bead first,
move swing arm out, install the tube, and then mount
the upper bead.
When you have completed the mounting process,
proceed to inflation.
Inflation
Do not inflate tire while wheel is clamped to
the Table Top. Tire failure under pressure is
hazardous. This tire changer Will Not
Restrain Exploding Tires, rims or other
related equipment. Inspect tire and wheel
carefully for match, wear, damage, or
defects before mounting. Always use
approved tire bead lubricant during mount-
ing and inflation.
Do not inflate tire while wheel is clamped to the table
top. Remove tire and wheel assembly from machine to
inflate. Use a remote controlled inflation device when
inflating; to seat beads, use a small amount of air inter-
mittently; never exceed the tire manufacturer’s recom-
mendation when inflating. If beads do not seat,
remove air and relubricate beads. After tire is properly
inflated secure bead locks were required.
ATV Tire Inflation: ATV tire inflation is unique in that
the bead seat pressure allowed is more than the oper-
ating pressure. ALWAYS follow the tire manufacturer’s
information on inflation. This information can be printed
on the sidewall, on the tire sticker, or from the manu-
facturer.
DANGER
Important: Always read and follow the operating instructions. • 7