COATS Kit 85607770 Tire Inflation Cage - Manual

85607790 01a 01/14 1 of 1 © Copyright 2012 Hennessy Industries and COATS All Rights Reserved
EL-X Express Lane ®
Infl ation System
For use with COATS Tire Changers
Hennessy Industries • 1601 J. P. Hennessy Drive, LaVergne, TN USA 37086-3565 (800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com
DO NOT REACH
INTO CAGE
DURING INFLATION
Location of Tire Inflation Cage
Provide at least three feet of clear space between the
Tire Inflation Cage and building walls. When a tire fails,
the explosive release of air will throw all movable objects
in the path of the expanding compressed air.
The Tire Inflation Cage may be attached to a tire changer
using a COATS Tire Inflation Cage bracket.
Using Tire Inflation Cage
1. Always keep the floor clear of dirt and debris inside
and around the cage area.
2. Be sure to clean tire and rim of any loose debris.
3. Roll the tire assembly into the cage. Center the tire,
in the cage, in an upright position. Rotate tire so inflation
valve is between inflation cage tubes.
4. Use a clip-on chuck and remote inflation and defla-
tion valve.
ALWAYS STAY CLEAR OF TIRE INFLATION
CAGE DURING APPLICATION OF AIR.
Inspect Tire Inflation Cage Monthly
INSPECT cage for damage. Loose or weakened parts
can fly in a tire explosion.
DO NOT USE cage if tubing is visibly bent, or shows
visible cracking at welds.
OK
DO NOT STAND IN
TRAJECTORY ZONE
ALWAYS WEAR
SAFETY GOGGLES
WARNING
Risk of explosive release of compressed
air and flying parts and debris during tire
mounting and tire inflation. You can be
killed, blinded, or seriously injured.
- Read, Understand, and Follow All Instructions
- Adhere to Federal Regulations for Tire Mounting
- Wear Safety Goggles
WARNING
It is NOT SAFE to use the Tire Inflation Cage
for inflation of the following type of tires:
• Tires Defined as Truck Tires
• Tires on 2-piece Rims
• Small Tires (Rim Smaller than Cage Tube
Spacing)
For servicing only single piece automotive, and
light truck tire/wheel assemblies.