COATS Kit 8184553, Nitrogen Inflation System User Manual

Page 7

5. From the back side of the machine, manipulate the

1/4-inch valve through the access opening. Next, cut
the 1/4-inch rubber hose supplying air to the valve. This
hose is between the 1/4-inch brass valve and the 3/4-
inch brass valve.

6. Using the 1/4-inch bolt (from kit), insert it into the

cut hose and with the hose clamp (from kit) secure the
bolt inside the hose. This will prevent air escaping at the
3/4-inch valve.

7. With wrenches, remove the cut hose from the

valve fitting. Next, install the new length of hose from
kit into the valve with clamp (from kit) and tighten.
Route the opposite end of the hose to the end of the
machine for connection to the nitrogen supply service.

8. Next, reposition the 3/4-inch valve with spacer and

install the retaining nut; do not over tighten the nut.
Next install the 1/4-inch valve with spacer and route the
black plastic hose as before to the foot valve end of the
machine.

9. Reattach the black plastic hose to the repeater

valve.