COATS Air-Check Automatic Tire Gauge - Manual

Technical Characteristics
1
Electrical Requirement 110 Vac ± 10%
Electrical frequency 50 / 60 Hz
Electrical consumption 10 W
Default pressure 32 psi
Maximum pre-set pressure 90 psi
Minimum supply pressure 100 psi
Maximum supply pressure 175 psi
Average airflow 0,5 m³/min
Accuracy < 1% F. S.
Operating Temperature +14  +122 °F (-10  +50 °C)
Air relative humidity (without condensation) 0  95%
Weight 6.0 Lbs
Installation
2
2 For wall mounting:
2.1 Use the unit’
s bracket as a guide to pre-drill holes; then install the unit to the wall.
2.2 Place the unit in the bracket.
2.3 Before installing the supply pressure hose, let the air flow for some seconds, so as to
remove all dirt and humidity.
2.4 Install the supply pressure hose and the tire hose.
THE SUPPLY PRESSURE SHOULD NOT EXCEED 175 Psi (12 Bar). IF NECESSARY, USE A
PRESSURE REGULATOR.
2.5 Plug Tire Gauge into a compatible power supply.
3
Functioning
3.1 Set pressure using buttons and .
3.2 Connect chuck to tire ; inflation procedure will start automatically.
Important: DO NOT use to inflate wheels smaller than 10 inches in diameter.
3.3 If flat, push button to start inflation process.
3.4 Wait for the “beep” .
3.5 Remove chuck from the tire that has been inflated to the desired pressure and
repeat the process for any other tires. If you intend to fill the same pressure value just
connect chuck to the new tire and wait for the beep.
3.6 When set pressure is higher than 40 PSI, and starts with zero pressure, the unit will
stop at 40 PSI and ask for confirmation. Check tire and press the green button to
complete tire inflation procedure.
Maintenance
4
To ensure proper performance and longer life, some procedures are recommended:
4.1 Never allow supply pressure to exceed 175 Psi (12 Bar).
4.2 Chuck must be replaced every time air loss is noticed. ONLY USE AN “OPEN END”
CHUCK”.A closed end chuck will not work properly.
4.3 It is recommended to keep the air line free from dirt to avoid clogging the filter.
4.4 It is recommended to perform a regular cleaning on the front panel using soap
and water.