COATS HIT 5000H2 Truck Tire Changer - Manual (Page 20)

6. Remove the pressure sensor tubing. Remove the
wheel nuts.
7. Extend the ram to full length, install the yoke
extension, and tire compressor making sure that the
legs will not catch on the edge of the rim.
8. Actuating the ram downward, move the tire off of
the bead seat.
9. Remove the tire compressor and upper rim sec-
tion.
10. With another person holding the wheel in place,
extend the carriage to move the wheel and end plate
back to the vertical position.
ALWAYS be aware of what each person is
and will do before attempting any two-per-
son operation.
11. Roll the wheel around and onto the carriage.
12. Move the carriage inward to position the wheel
with the jaws in the center. Expand the arms so that
the outer notch in the jaws clamp onto the inner rim of
the wheel.
Use care to avoid contact with the studs
and air intake pipe, which can result in dam-
age to the rim.
13. Raise the wheel and place the super single/dual
wheel roller assembly in the carriage hole closest to
the body of the machine behind the tire.
CAUTION
WARNING
H.I.T. 5000H2
14 • COATS H.I.T. 5000H2 Changer