COATS 9500R Electro-Hydraulic Tire Changer - Manual (Page 8)

2.0 Carriage Instructions
The machine is crated in a wooden box of appropriate
strength.
The box is mounted on a pallet.
Handling of the machine must be performed with an
appropriate lifting device (fork lift) (fig.10).
Fig.10
2.1 Uncrating Instructions
Always wear gloves
when uncrating the machine to prevent scratches,
abrasions, or cuts due to the contact with packing
materials.
Uncrate the machine paying attention when removing
the nails or during any other operation which may be
hazardous.
After removing the crate, check for any visible dam-
age to the machine and its components.
If in doubt, call qualified personnel for assistance.
The packing materials (plastic bags, polystyrene, nails,
screws, wood etc.) must be properly disposed of.
Place the above-mentioned materials into a trash con-
tainer and dispose per local regulations.
2.2 Installation Area
Install the machine in a covered and dry area.
The installation of the machine requires a free space
of at least cm 16’ 5” x 16’ 5” (500cm x 500cm) (fig.11).
Fig.11
Make sure that from the operating position (fig. 11)
the user can see all of the machine and the surround-
ing area.
Only authorized operators of the equipment should
be in the work area. Keep the work area clean and clear
of objects which may create possible hazards.
It is the responsibility of the facility owner to properly
designate work areas and areas where by-standers are
not permitted.
Install the machine on a horizontal floor, preferably
even. Do not install the machine on a sinking or irregu-
lar floor.
In case the machine is installed on a raised floor or on
a service vehicle, the floor must have a capacity of at
least (330 lbs. x sq. ft.). Please contact COATS directly
at 1-800-688-9240 to discuss options and other pre-
cautions that may apply.
Drill (1/2”) holes in the floor flush with the holes
provided in the cabinet.
Place the lags into the holes drilled in the floor and
move the machine so that the holes of the cabinet are
flush with the holes in the floor.
Tighten the screws to (50 ft. lbs.).
CAUTION
4 • COATS 9500R Tire Changer