COATS 520 Wheel Lift - Manual (Page 8)

4. Move the toggle switch upward (Position 1). The
wheel will be clamped between the upper and
lower wheel clamps and raised to the height of
the balancer stub shaft.
During this operation, do
not put your hands on the
top of the wheel. Your
hands could be pinched between the wheel and
the clamp.
5. Use the handle, labeled item 2 in Fig. H, to
move the upright, labeled item 6 in Fig. H, for-
ward until the wheel is on the balancer stub
shaft and ready to be mounted on the balancer.
6. Secure the wheel to the balancer using suitable
mounting adapters.
7. Move the toggle switch, labeled item 1 in Fig. H,
to the center (Position 0) to release the wheel
from the clamps.
8. Move the upright, labeled item 6 in Fig. H, back-
ward to free the wheel balancer work area.
9. Balance the wheel.
10. Move the upright, labeled item 6 in Fig. H, for-
ward until the wheel clamps, labeled items 4 & 5
in Fig. H, are positioned on the wheel.
11. Move the toggle switch up (Position 1) to clamp
the wheel between the wheel clamps.
During this operation, do
not put your hands on the
top of the wheel. Your
hands could be pinched between the wheel and
the clamp.
12. Remove the wheel from the balancer stub shaft.
13. Move the upright backward to create the space
needed to unload the wheel.
14. Move the toggle switch, labeled item 1 in Fig. H,
down (Position 2) to lower the wheel and
release it from the clamps.
15. Turn the wheel by hand until it comes out of the
lower wheel clamp.
6 • 520 Wheel Lift
DANGER
DANGER