CHAMPION PP3 - Manual (Page 9)

1
Installation
1. Inspect the machine and shipping pallet for signs of damage.
2. Options and accessories may have shipped in separate boxes with your sink.
3. Turn to the front of this manual and follow the instructions to register your product
online or by fax.
NOTE:
The installation of your power wash sink must be performed by qualified service personnel.
Problems due to improper installation are not covered by the Warranty.
NOTE:
The installation of the power wash sink must comply with all local electrical, plumbing, health
and safety codes or in the absence of local codes, installed in accordance with the applicable
requirements in the National Electrical Code, NFPA 70, Canadian Electrical Code (CEC),
Part 1, CSA C22.1; and the Standard for Ventilation Control and Fire Protection of
Commercial Cooking Operations, NFPA 96.
4. Refer to the illustration on page 2 showing a sample PP-3 configuration.
5. Check the location of the building plumbing connections and move the unit to its
permanent location.
6. Note the location of the electrical connection (1) and the drain connections (2) and (2A)
in the sample illustration.
NOTE: YOUR MACHINE WILL BE DIFFERENT.
The PP-3 sink is customizable including: length of drainboards, and tanks as well as
direction of operation.
7. Remove the protective wrap and any hold-down straps.
8. Carefully remove the machine from the pallet. Do not lift by the drain assemblies.
9. Using the sink adjustable feet and a bubble level, level the sink front to back and
side to side. The standard height for the sink table is 34"/864mm.
10. Most installations require the sink backsplash to be sealed to the wall with sealant.
Placement
Installation
Receiving